JDSU TP607 Guide de l'utilisateur télécharger pdf (Page 10)

Instructions for Use

LanRoamerPRO

™

powers off automatically

after 5 minutes of continuously testing a

cable when auto-on powered up the tester.

Disconnecting the cable restores normal

function. Most power-on modes will timeout

in about 18 minutes, except for tone, which is

about 2.4 hours. Be sure to install a battery if

using for the first time—see battery installation.

Cable Testing

To Test a Patch Cable (see “Caution!” on

page 1 about cables with bad plugs)

1) Plug one end of patch cable into main unit.

2) Plug other end of cable into remote unit.

3) The tester will power on immediately and

will indicate a test in progress by displaying

the TEST icon. It will be followed by map

results plus a PASS icon and a beep, if it

passed both the T568A/B standard and the

configured shield criteria.

4) Disconnect patch cable after test. The test

repeats every 5 seconds.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

JDSU TP607 Guide de l'utilisateur Page 10