JDSU TP607 Guide de l'utilisateur télécharger pdf (Page 13)

10

To Test Coax (tester off or in TEST/PRE-TEST

mode)

1) Plug RJ45 to F coax adapters into the

remote and main units.

2) Attach cable to be tested to F connectors.

3) The tester will power on if it senses the

cable. If not, the cable is open. The coax

adapter is connected to the 1-2 pair and will

display “12” on the second line if good and

flashing “xx” if shorted.

4) Length may be measured as well by setting

length constant and selecting 1-2 pair.

To Place Tone on a Cable

1) Turn on unit by pressing any button. If not

in tone mode, press MODE until TONE is

displayed, than press SEL button.

2) Press SEL until desired tone is selected.

The up/down arrow keys select the pin or

pair(s) to carry the tone.

3) Connect cable to be traced to main unit.

For best signal, do not connect remote. Due

to the shielding effect of twisted pairs, the

strongest signal is obtained by having one

wire of a pair carry tone. Selecting a single

pin instead of a pair will do this.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire