9
To Test Installed Cable (office jack to patch
panel with remote)
1)
Remove remote unit from main unit by
sliding remote towards top of the main unit.
2) Attach one end of supplied one-foot patch
cable to the remote and other end to the wall
jack.
3) Attach one end of the second supplied one-
foot patch cable to the main unit and other
end to the patch panel jack.
4) The tester will power on immediately and
indicate a test in progress by displaying
the TEST icon. It will be followed within
2 seconds by a wire map display of the
results, plus a PASS icon and a beep if it
passed the set shield criteria and T568A/B
standard. The ID number for the remote will
also be displayed.
5)
Disconnect cable after test. The test repeats
every 5 seconds.
Application Hints: The jumper cables must be
short compared to the cable run for accurate
split pair indication – no more than 10% of the
total run length.
Commentaires sur ces manuels